Infinite Bandit Rifle – DIY

A DIY kit of raw 3d printed parts for a Bandit Rifle

Printed in pre-separated parts and needing assembled.

Please refer to the materials needed to complete this kit none of which are included:

Spring Kit: https://amzn.to/4bcu708

• Uses the 9/32” x 2-13/16” expansion spring for the slide
• Uses the 9/32” x ¾” compression springs for the trigger

2mm diameter metal rods: https://amzn.to/3HxS985

• Used to pin the spring in place at 1 end

5mm diameter metal rod: https://amzn.to/4bgpTVa

• Used to strengthen the pull

10 x 3mm magnets: https://amzn.to/3HHmktD

• Uses 4 to hold the magazine in place

Uses a ½” diameter wooden dowel down the center

• Available at most large grocery/craft stores
• 85cm length and 80cm length