Galactic Marine Clone Trooper Armor – 3D Print Files

3D Print Files for the Galactic Marines as seen in Revenge of the Sith

These files are build from the ground up to be wearable and be 501st approvable.
Using reference images from the CRL we’ve built the most accurate Galactic Marine armor available!

These files include all the hard surface parts necessary including:
Helmet, Chest, Back, Backpack, Pauldron, Shoulders, Biceps, Elbow Pads, Forearms, Hand Pads, Knee Pads, Calves, Boot Cover, Belt Details

Some details about the armor:
The Backpack is separate from the back armor and can be attached with the 4 hooks along the back armor piece. The backpack also has 3 connecting pieces which snap into pre-made connecting points.
The helmet domes comes in two versions, with and without a mesh along the back stripe. This is to allow you to insert your own mesh if you want to use a separate non 3d printed material.

Note some parts are not included, like the belt, since they are specified to be made out of fabric.

If you would like to use these files for commercial use, please subscribe to the “Specialist” tier of my Patreon here: https://patreon.com/galacticarmory